Irzaman*, .- and Ridwan Siskandar, .- and Brian Yuliarto, .- and Mochamad Zakki Fahmi, .- and Ferdiansjah, .- (2020) Application of [Ba. sub. 0.5][Sr. sub. 0.5] Ti [O. sub. 3](Bst) Film Doped with 0%, 2%, 4% and 6% Concentrations of Ru [O. sub. 2] as an Arduino Nano-Based Bad Breath Sensor. Chemosensors, 8 (1). pp. 1-11. ISSN 2227-9040

	Text (Fulltext) C27. Fulltext_.pdf Download (29MB)
	Text (Penilaian dan Validasi) C27. Penilaian dan Validasi.pdf Download (1MB)
	Text (Similarity) C27. Similarity.pdf Download (3MB)

Abstract

Ba0.5Sr0.5TiO3 (BST) film doped with variations in RuO2 concentration (0%, 2%, 4%, and 6%) has been successfully grown on a type-p silicon substrate (100) using the chemical solution deposition (CSD) method and spin-coating at a speed of 3000 rpm for 30 s. The film on the substrate was then heated at 850 °C for 15 h. The sensitivity of BST film + RuO2 variations as a gas sensor were characterized. The sensitivity characterization was assisted by various electronic circuitry with the purpose of producing a sensor that is very sensitive to gas. The responses from the BST film + RuO2 variation were varied, depending on the concentration of the RuO2 dope. BST film doped with 6% RuO2 had a very good response to halitosis gases; therefore, this film was applied as the Arduino-Nano-based bad-breath detecting sensor. Before it was integrated with the microcontroller, the voltage output of the BST film was amplified using an op-amp circuit to make the voltage output from the BST film readable to the microcontroller. The changes in the voltage response were then shown on the prototype display. If the voltage output was ≤12.9 mV, the display would read “bad breath”. If the voltage output >42.1 mV, the display would read “fragrant”. If 12.9 mV < voltage output ≤ 42.1 mV, the display would read “normal”.

Actions (login required)

View Item